Tara's Makeup Notes for me as Artist

Step by step for Tara's makeup design

Tools

• Flat foundation brush
Kabuki Brush
• Fluffy powder brush
• Flat eyeshadow brush
• Fluffy blending brush
• Small blending brush
• Very fine artist brush
• Angled brush

Products

• Luminous primer
• Foundation pallet
• Illamasqua skin base 001
• Illamasqua loose powder
• Illamasqua liquid metal pallet
• Colour Infallible eyeshadow by L’Oréal in the colour 001
• kroyaln lipstick pallet
• Kryolan Bright’s pallet
• Mixing medium
• Fake blood
• Matt grey toned eyeshadow

Method

• First using your flat foundation brush apply the luminous primer all over the face.
• Next apply your foundation to the face and lips with the same brush, a couple shades lighter than the natural skin tone, mix some primer into the foundation to make it super luminous.
• Now buff in using your kabuki brush.
• Apply concealer in the same shade as the foundation to the under eyes and any blemishes.
• To highlight the face mix the two silvers from the liquid metal pallet together and apply to high points of the face concentrating on the cheekbones.
• To intensify this highlight you can put a colour infallible eyeshadow by L’Oréal in the colour 001 time resist white on top using a fluffy powder brush.
• Use loose powder to matt down the areas where you haven’t used the silver.
• Place allot powder underneath the eyes to catch any fall down.
• For the eyes first start by using a flat brush and apply a red lipstick from your kroyaln lipstick pallet in a round shape just above the crease and under the eye.
• Blend with a fluffy brush.
• Set the lipstick with a loose powder.
• Now to intensify this colour apply a red eye shadow from your Kryolan Bright’s pallet with a flat brush only to the mobile lid.
• Now buff the edges using a blending brush so that the colour fades from dark on the lid to light around the edges.
• Use a small flat brush to push the red on the bottom lash line and blend out, take the colour all the way to tear duct.
• Blend the colour slightly, but not to low down.
• For the eyebrows fill then in using a matt grey toned eyeshadow and an angled brush. Using a mascara wand brush through the brows with a small amount of silver from the Liquid Metals pallet.
• For the lips on top of the foundation apply a small amount of sliver in the centre.
• Now to create the tear mix red eyeshadow with mixing medium from Ilammasqua and paint on using a very fine brush. In the tear duct area place a small amount of fake blood and allow to dribble down slightly.
Finally for the Hand print cover your hands in red supra colour, now place the hand on to your models neck to make the print.

0 comments:

Post a Comment

Powered by Blogger.
Back to Top